CH-24 Bead Breaker

The SU100A Stepper™ gives you safe and secure footing while you work on truck engines. This convenient tool goes over the front or rear tire of the vehicle to give you easier access to hard-to-reach places. It’s adjustable for most tire sizes and folds flat for convenient transport and storage.

The 6346 Complete PakPress® Kit is a must if you’re in the Fleet Maintenance industry.  Don’t be without this tool that brings the power of a 10-ton shop press right to the truck.  Most impressive, the PakPress® lets you remove and install studs without removing the hub. A two-hour job is done in twenty minutes, with no risk of damaging seals or bearings.

The 6346 Complete PakPress® Kit includes:

• 1-PPK PakPress®
• 6247 PakPress® Cart
• Adapters ( 6261,6235, 6236, 6361)

The 350B Back Buddy II™ will make brake jobs easier and more profitable. This versatile tool was designed to prevent injuries from awkward lifting and keep workers’ comp rates down. The Back Buddy II™ rolls under and bolts onto heavy drum and hub assembly, then handily rolls the assembly out and lays it over for servicing. Re-assembly is quick and precise because the Back Buddy II™ angles for perfect hub alignment, eliminating seal damage and costly fixes. The Back Buddy II™ handles all hub and drum assemblies with Universal Receiver and Adapter Sets. A simple change of adapters transforms the tool in seconds from inboard to outboard application.

*Adapters 6069 and 6073 10-hole inboard and outboard application are included
*Other wheel adapters sold separately.

The VV 3000 Versa Vac™ Radiator Pressure Tester and Coolant Dam will pay for itself after just a few uses. Ingenious and simple, this new time saving tool holds the engine coolant in, even when pipe plugs, sensors or valves are removed for replacement or repair. The Versa-Vac™ Pressure Tester creates a vacuum, holding coolant in with little or no loss. For many minor repairs, there is no need to spend valuable shop time draining and refilling the system. The Versa-Vac™ unit fits standard radiator necks and installs as quickly as a radiator cap.  Adapters are available to fit special applications. As a pressure tester, the Versa-Vac™ allows a quick check of your repair with positive pressure from shop air.  No tedious hand pumping.  A radiator cap installs on the tester to provide pressure relief. An inlet ball valve adjusts the pressure applied to the system up to the maximum limit of the relief valve.

Air requirement for continuous use: approximately 30 CFM at 120-150 PSI.

*** ADAPTERS REQUIRED AND SOLD SEPARATELY ***